About the Transmitter
6CH/IDLE Switch
Right hand throttle Left hand throttle
5GH/Gyro Switch
TH.HOLD Switch
Antenna
This transmitter supports CCPM 120 degree helicopter mode with 3D 6G
switching. It has high/low rates for two joystick modes, motor cutout switch
(TH.HOLD) and a large screen multi-function LCD display.
Exit
Rudder Trim
Menu
Throttlle/Rudder stick
Throttle trim
Neck strap bracket
Power Switch
LED Display
Dual Rates
Aileron/ Elevator
Stick
Page Down
Page Up
Aileron Trim
Elevator Trim
Forward Throttle
Backward
Left
Yaw
Left
Roll
Right
Roll
Throttle
Left
Yaw
Right
Yaw
Right
Yaw
Forward
Backward
Left
Roll
Right
Roll
2) Gyro adjustment
Users can adjust the FBL gyro according to their preference. Use a flat-blade
screwdriver to adjust. Turn clockwise to increase the value, and turn
counterclockwise to decrease the value.
1 Tail lock sensitivity 2 Swashplate agility 3 Swashplate sensitivity.
Flight Control Board Adjustment
1)Servo Centering Adjustment
Note: The product has been adjusted and inspected before leaving the factory.
The user needs to re-adjust the servo centering after replacing the servo or related
accessories.
To ensure safety, disconnect the main motor power during adjustment to avoid
personal injury caused by motor rotation.
If you have one, a swashplate levelling tool allows more accurate adjustment.
First, bind the heli and set the transmitter to 6G self-stabilization mode.
Press the bind button on the flight control board 4 times, the mainboard will flash red
quickly and enter the adjustment mode.
Use the transmitter sticks to adjust the aileron, elevator and rudder servos until the
swashplate is balanced and the blades are at 0 degrees pitch.
After the servo adjustment is completed, press the mainboard bind button to exit.
The red and blue light on the mainboard will be lit.
You can now fly.
Press 4times to enter
servo adjustment mode
Alleron tx stick
Rudder tx stick
Elevator tx stick
-8--7-
To Next Page
Loading...
Need help?
General
