3.0 ESC
Continuous current: 40A
Peak current: 45A (10S)
BEC output: no
Input voltage: 2-6S
Main control chip: 48mhz EFM8BB2
Firmware upgrade: Supports Dshot150-600/Multishot/Oneshot/PWM
Size: 37.5x37.5mm
Mounting Hole: 30.5x30.5mm
BAT: power positive electrode;
GND: power negative electrode;
5V:5V regulated power supply
output interface,maximum current 2A;
S1-4: throttle signal input interface,
S1 corresponds to M1.S2 corresponds
to M2, S3 corresponds to M3, S4
corresponds to M4.Number electric
adjustment;
POWER INPUT: power line pads, "GND"
corresponding power supply.The line
negative pole, "BAT" corresponds to the
positive pole of the power supply line.
Interface definition chart:
-5-
TYR O 129
QUICK START GUIDE
Features:
High-performance EFM8BB21F16G microprocessor with operating
frequency up to 48MHz;
Japan's Toshiba 5×6 package MOSFETs are more reliable than 3×3
package MOSFETs;
6-layer high TG 3OZ copper-thick PCB board, which greatly reduces
heat generation and is more efficient;
Use the BLHeli_S open source program to upgrade the firmware or
change the ESC parameters via the throttle signal line to support all
BLHeli_S functions;
ESC can support DShot150/300/600 digital throttle mode and common
PWM, OneShot125, OneShot42, MultShot throttle mode;
Built-in 5V@2A BEC, can supply power for flight control, camera,
image transmission, LED lights, etc.
To Next Page
Loading...
