5.0 Camera
6.0 Switchable VTX
Case size: 19x19x16mm
Weight: 5.5g
Signal system: NTSC / PAL (Switchable)
Resolution ratio(horizontal center): 1200TVL
Video output Signal: cvbs
Image: 16:9
Synchronization method: inter-sync
Camera lens: standard 2.1mm
Lens operating voltage: DC 4.5-40V
S/N Ratio: >52dB (AGC OFF)
Audio: YES
Output power & transmission distance: ≥0.5km@25mW,
≥1km@200mW, ≥2km@600mW
Transmitting power: 0mW/25mW/200mW/600mW
Full video format: NTSC /PAL
Input voltage & power dissipation: 7V~24V, +12V/260mA@600mW
Size: 20*30*9mm
Weight: ≤7g(except antenna)
With output power self-check function.
Nixie tube SCAN: frequency point (1-8), frequency band (A-E),
power (1-3, 0=0mw, 1=25mw, 2=200mw, 3=600mw)
-7-
TYR O 129
QUICK START GUIDE
Frequency control method:
Button frequency control (1-8): press the button for 2 seconds
to enter the frequency setting, and press the button to change
the frequency CH1-8.Change the frequency band (A-E), set the
frequency, press the button for 2 seconds, then press the button
to change the frequency group FR (A-E).
Points for attention:
The antenna is installed at the output terminal before power up,
so as not to damage internal components.Note that the input
voltage is within the specified range and is positive or negative,
so as not to damage internal components.If the antenna is replaced,
choose a standing wave and a good gain antenna to obtain a longer
transmission distance.Attention should be paid to electrostatic
protection during transportation and installation.
To Next Page
Loading...
