"001--512"; Press “ENTER” to confirm exit, press “ESC” to abandon exit.
3. To accept the mainframe synchronous (from the models), you have to set the address value as
"001".
4. In the address value situations, if you install DMX controller without connecting, the display
will twinkle; if you install connecting DMX controller, the display will not twinkle; but the
signal light will twinkle ,only the signal is exit.
二、 DN. Pr. （DMX Pre-Setting）
This function let you to choose different operating modes.
1. Press the "up" or "down" keys to browse other menus.
2. Press “ENTER” to enter, then press “UP” or “DOWN” and choose “nod.1” or “nod.2”,then
press “enter” to save and exit or press “ESC” to exit directly.
Nod.1: [mode 1] the normal channel value controlling
Nod.2: [mode 1] the fewer channel value controlling
3. To accept the mainframe synchronous (from the models), you have to pre-set the DMX as
“nod.1”.
三、 Testing Procedures
This function allows you to take inner demonstration procedures without external connector. This setting
will be kept up, If you don’t exit the testing procedure, you will automatically enter the testing procedure,
once you start up it every time.
Press “UP” or “DOWN” keys to browse other menus, press “ENTER” to enter.
1. nod. 1 [testing mode 1]
Press “ UP” or “DOWN” to select other modes, press “ ENTER” to enter, showing “RUN”
testing work. If you need to exit, please press “ ESC”.
2. nAst: [mainframe controlling]
This function allows you to test directly, which don’t require mainframe to send DMX synchronous
signal to deputy plane.
Press “UP” or “DOWN” to select other modes, press “ENTER” to enter, appear “ON” as mainframe
sending out signal, the DMX signal light on. Appear “OFF” as mainframe don’t sending out signal, the
DMX signal light crush out, press “ ENTER” to save and exit, press “ESC” to exit directly. After setting
“ON”, you have to cut off external DMX controller, which don’t allow two or more mainframes with
same setting in the same connecting road.
四、 Audi [ Sound- controlled Stimulating ]
This function allows you to use sound stimulated testing prosecutor.
1. Press “ UP” or “DOWN” to browse other menus.
2. Press “ ENTER” to enter, then press “UP” or “DOWN” and select “ON” or
“OFF” showing whether using sound stimulating or not while testing.. “ON”
shows to use sound controlling, “OFF” shows not to use sound controlling,
controlled automatically in the testing mode. After setting “ON”, the audio singal
light will twinkle together with the music in the testing procedure.
五、r.Pan. [ Pan reverse in horizontal ]
This function allows you to reverse in horizontal.
Press “ENTER” to enter, use “UP” or “DOWN”, if you need to reverse, please select “ON”; if
To Next Page
Loading...
