Need help?Do you have a question about the Eagle Z-9500 and is the answer not in the manual?
General| Display Size | 5 inches |
|---|---|
| Power Output | 500 Watts (RMS) |
| GPS | No |
| Water Temperature Sensor | Yes |
| Transducer Included | Yes |
| Sonar Frequency | 200 kHz |
| Frequency | 200 kHz |
Install the Z-9500 in any convenient location, provided there is clearance behind the unit when it is tilted for the best viewing angle.
The Z-9500 works from a twelve-volt battery system only. You can attach the power cable to an accessory or power buss.
When the Z-9500 is first turned on, the Automatic feature is enabled. It adjusts sensitivity and range for optimal bottom signal display.
Controls the unit's ability to pick up echoes. Adjust sensitivity to balance detail with screen clutter from noise.
Triggers an alarm when echoes appear within a defined bar on the screen. Alerts on fish, structure, or bottom echoes.
Sounds an alarm when the bottom signal goes shallower or deeper than the set point. Useful for anchor watch.
A type of Bottom Alarm that sounds when the bottom signal goes shallower than the set point.
Sounds a tone when the Fish ID feature displays a fish symbol. Uses different tones for different fish symbol sizes.
Displays the bottom depth at the top left of the screen. Shows depth in feet, fathoms, or meters.
Calibrates the speedometer display to accurately show the boat's speed using a measured mile or known speed.
Compensates for transducer installation depth relative to the hull's lowest point for accurate water depth readings.
Adds transducer depth to bottom depth to display true water depth from the surface to the bottom.
Automatically applies ASF corrections based on built-in tables for improved position accuracy.
To Next Page
