23
Go to Table of Contents
Regulatory Compliance Statements for the EAR FORCE
Stealth 520 RX & TX
Federal Communications Commission (FCC) Compliance Notices
This section includes the following FCC statements for the EAR FORCE Stealth 520 RX & TX:
· FCC ID: XGB-TB2670(Headset) · FCC ID: XGB-TB2671(Transmitter)
· Class B Interference Statement · RF Radiation Exposure & Hazard Warning
· Non-Modification Statement · Deployment Statement
Class B Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
RF Radiation Exposure & Hazard Statement
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the
device will be greater than 2 cm (0.8 in.) from all persons. Using higher gain antennas and types of antennas not covered under the
FCC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation
instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other antenna
or transmitter.
Non-Modification Statement
Use only the supplied internal antenna. Unauthorized antennas, modifications, or attachments could damage the EAR FORCE
Stealth 520 RX & TX Models and violate FCC regulations. Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. Please contact Turtle Beach for a list of
approved 2.4 GHz antennas.
Canadian ICES Statements IC: 3879A-TB2670 (Headset) 3879A-TB2671 (Transmitter)
This device complies with ICES-003 and RSS-247 of Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
Ce dispositif est conforme aux normes NMB003 et CNR-247 d’Industrie Canada.
1. L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
2. il ne doit pas produire de brouillage et l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is intended to be operated
indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is
subject to licensing and not supported by EAR FORCE Stealth 520 RX & TX Models.
RF Radiation Exposure & Hazard Statement
To ensure compliance with RSS-102 RF exposure requirements, this device must be installed in a location such that the antenna of
the device will be greater than 2 cm (0.8 in.) away from all persons. Using higher gain antennas and types of antennas not covered
under the IC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the
installation instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Exposition aux radiations RF & Mention de danger
Pour assurer la conformité avec les exigences RSS-102 d’exposition aux RF (Radio Fréquences), cet appareil doit être installé dans
un endroit ou l’antenne de l’appareil sera située à une distance de plus de 2 cm (0.8 po) de toutes personnes. L’utilisation d’antennes
à gain plus élevé et les types d’antennes qui ne sont pas couverts en vertu de la certification IC de ce produit n’est pas autorisée.
Les installateurs de la radio et les utilisateurs du produit final doivent se conformer aux instructions d’installation fournies dans ce
manuel. Cet émetteur ne doit pas être co-implanté ou exploité en conjonction avec toute autre antenne ou transmetteur
To Next Page
Loading...
