Need help?Do you have a question about the EARDATEK KINGSAT P8 and is the answer not in the manual?
A checklist for initial antenna setup and site preparation steps.
Guidelines for selecting and preparing the Above Deck Unit installation site.
Guidelines for preparing the Below Deck Unit, including ACU and Modem.
Instructions for physically mounting the antenna onto the mast.
Visual guide for connecting antenna, ACU, and modem components.
Procedure to verify all cable connections are secure and correct.
Steps for ACU power-on and initialization process.
Configuration of IP address and network settings for the ACU.
How to access and log into the ACU's web interface.
Checking and understanding the antenna's operational status indicators.
Procedure for the antenna to lock onto and track a satellite.
Steps to test and verify the internet connection.
Finalizing setup and enabling internet access for IP devices.
Configuring the lock mode via the web interface settings.
Setting IP and communication protocol via web interface.
Verifying IP settings on the web interface's home page.
Verifying the OPENAMIP communication protocol functionality.
Monitoring the system while it waits for satellite tracking to establish.
Assessing the quality and status of satellite tracking.
Description of the ACU's main display and status monitoring.
Overview of the web interface home page and its sections.
Details on viewing the antenna's current geographical location.
Information on antenna pointing status and gyro data.
Details on Receive (Rx) and Transmit (Tx) parameters.
Information regarding IP address settings and network configuration.
Monitoring ACU voltage, power, and network status.
Information on ADU and BDU firmware versions.
Details of the modem's status, serial number, and SNR.
Instructions for upgrading the BDU firmware via web interface.
Procedure for performing CPI tests using the web interface.
Manual modification of Rx parameters through the web interface.
Manual adjustment of GNSS and Time Zone settings via web.
Performing elevation adjustments using the web interface.
Viewing antenna status in TVRO mode via web interface.
Steps for upgrading the BDU firmware using a USB flash drive.
Procedure for upgrading ADU firmware using a mobile app.
List of error codes and their corresponding solutions for antenna issues.
Identification of common reasons for SATCOM link failure.
Troubleshooting using the web interface for search or tracking issues.
Steps to verify hardware using TVRO mode and satellite data.
Using manual mode via web interface for antenna testing.
Frequently asked questions and answers for common operational issues.
To Next Page
General
