EarthQuake 14267 - User Manual

Questions and Answers

D
Deanna HendersonAug 1, 2025
What to do if the vacuum is not working on EarthQuake 14267?
- C
  Courtney JonesAug 1, 2025
  If the EarthQuake Chipper's vacuum isn't working, consider these potential causes: * **Hopper lid not in place:** Install the lid. * **Material too wet:** Allow the material to dry. * **Hose not attached properly:** Attach the hose per the instructions (see the Hose Kit). * **Hose obstructed or damaged:** Clear any blockage or replace the hose. * **Engine not running at full RPM:** Set the throttle control to FAST.
B
Brandon AndersonAug 7, 2025
What to do if EarthQuake Chipper runs but no material is discharged?
- M
  Michelle LeonAug 7, 2025
  If the EarthQuake Chipper engine runs, but no material is discharged, check the following: * **Discharge chute clogged:** Clean out any debris. * **Engine not running at full speed:** Set the throttle control to FAST.
P
pshermanAug 12, 2025
Why EarthQuake Chipper engine exhaust is black?
- S
  Sandra JohnsonAug 12, 2025
  Black exhaust from your EarthQuake Chipper engine can result from: * **Dirty air filter:** Replace the air filter (refer to the engine manual). * **Choke closed:** Open the choke.
J
janethardyAug 18, 2025
Why is there unusual noise or vibration when chipping materials with EarthQuake 14267 Chipper?
- C
  christopher10Aug 18, 2025
  Unusual noise or vibration when chipping materials with your EarthQuake Chipper can be caused by: * **Rotor overloaded with material:** Allow the unit to clear itself before adding more material to the hopper. * **Hammers are broken, bent, or loose:** Check the assembly and tighten or replace parts as necessary. * **Hammers frozen in place:** Check for obstructions and debris, then repair or replace parts as needed.
S
Stacey CameronAug 25, 2025
Why is there excessive branch vibration when chipping materials with EarthQuake 14267?
- J
  jwalkerAug 25, 2025
  Excessive branch vibration when chipping materials with your EarthQuake Chipper may occur due to: * **Chipper knives dull:** Sharpen or replace the chipper knives. * **Tree limbs are extremely hard or dried out:** The material may not be suitable for chipping.