EarthQuake 6014V CRT User Manual

OPERATOR INSTRUCTIONS AND PARTS
CRT Models 6014V
Page 15
GetEarthquake.com
800-345-6007
BELT REPLACEMENT PART #’S:
31315 (forward belt)
CHANGE FORWARD/REVERSE BELT
1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Remove belt guard. (SEE FIGURE 6)
• remove the forward belt from the forward engine pulley:
- gently pull the engine recoil rope to rotate the pulley.
- with the pulley turning, force the forward belt out of the
V-groove.
- slide the belt free of the engine pulley.
- pull the forward belt down and out of the way.
• install new forward belt:
- place forward belt in transmission pulley groove.
- gently pull the engine recoil rope to rotate the pulley while
forcing the forward belt into the V-groove.
4. Re-attach belt guard.
5. Attach spark plug wire.
DO NOT OPERATE TILLER BEFORE READING
THE ENGINE MANUAL PROVIDED IN THE PARTS
PACKET.
CAUTION
!
TEMPERATURE OF MUFFLER AND NEAR BY AREAS
MAY EXCEED 150° F. AVOID THESE AREAS.
WARNING
!
IMPORTANT
ENGINE CAN OVERHEAT AND BECOME DAMAGED
IF DEBRIS BLOCKS THE COOLING SYSTEM OR
ROTATING SCREEN.
NEVER RUN ENGINE WITHOUT COMPLETE AIR
CLEANER INSTALLED ON ENGINE.
FIGURE 6
engine pulley
forward belt
transmission pulley

EarthQuake 6014V CRT Specifications

General

Brand	EarthQuake
Model	6014V CRT
Category	Tiller
Language	English