OPERATOR INSTRUCTIONS AND PARTS
CRT Models 6014V
Page 19
800-345-6007
PROBLEM REMEDY/ACTION
Belts squeal in neutral • Adjust forward belt guide:
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark plug
- remove belt guard
- pull down on drive safety control lever
- manually bend forward belt guide so there is 1/16 inch
or less clearance between belt guide and belt
- replace belt guard and spark plug wire
Excessive heat build up in transmission/tine
area during tilling
• Remove vegetation by following instructions in Clean
Tine Axle Shaft of Normal Care section.
FOLLOW ALL SAFETY INSTRUCTIONS
• Check transmission fluid and fill if needed