EarthQuake VERSA 25780 SERIES

Questions and Answers

B
Brent LoganAug 15, 2025
What to do if EarthQuake VERSA 25780 engine will not start?
- R
  Rhonda LeeAug 15, 2025
  If your EarthQuake Tiller engine won't start, try the following: * Add gas to the gas tank. * Connect the spark plug wire to the spark plug. * Ensure the ON/OFF switch is turned ON, and the engine is choked for a cold start.
D
Daniel AndersonAug 18, 2025
Why does my EarthQuake VERSA 25780 engine miss or lack power?
- R
  robert75Aug 18, 2025
  Your EarthQuake Tiller engine may be missing or lacking power due to several reasons. You can try the following: * Raise the drag stake for shallower tilling. * Clean or replace the air cleaner. * Replace the spark plug and adjust the gap. * Drain and refill the gas tank with fresh gasoline. If the issue persists, the carburetor adjustment may be improper, and you should take it to an authorized engine service center.
J
Joseph KeithAug 21, 2025
Why is my EarthQuake Tiller engine hard to start?
- M
  Melissa FryeAug 21, 2025
  If your EarthQuake Tiller engine is hard to start, consider these solutions: 1. Drain the old fuel and replace it with fresh fuel. Use a gas stabilizer at the end of the season. 2. Make sure the spark plug wire is securely attached to the spark plug. 3. Ensure the drive safety control lever is released to neutral to start the engine.
R
Robert GriffinAug 26, 2025
What to do if EarthQuake Tiller engine runs rough, floods during operation?
- P
  Peter OrtegaAug 26, 2025
  If your EarthQuake Tiller engine runs rough and floods during operation, clean or replace the air cleaner.
R
Rebecca MitchellAug 28, 2025
Why do belts squeal in forward operation of EarthQuake VERSA 25780 Tiller?
- J
  jshafferAug 28, 2025
  If the belts squeal during forward operation of your EarthQuake Tiller, you can try the following: * Adjust the belt tension with the engagement cable. * Replace the drive belt.
M
Mark GarnerSep 1, 2025
What to do if my EarthQuake VERSA 25780 is difficult to control when tilling?
- C
  Christina RichardsSep 1, 2025
  If your EarthQuake Tiller is difficult to control while tilling (machine jumps or lurches forward), try the following: * Lower the engine speed in hard ground. * Lower the drag stake for greater resistance and control of the tiller.
J
jcannonSep 4, 2025
Why does my EarthQuake VERSA 25780 move forward during starting?
- B
  Brett MejiaSep 4, 2025
  If your EarthQuake Tiller moves forward during starting, make sure that the drive safety control lever must be released to neutral to start the engine. Also, check the belt tension.
R
rwrightSep 7, 2025
What causes excessive heat in transmission/tine area during tilling with EarthQuake Tiller?
- M
  Madison PrinceSep 7, 2025
  If you notice excessive heat build-up in the transmission/tine area of your EarthQuake Tiller during tilling, try the following: * Remove any vegetation that may be causing obstruction. * Check the transmission lubrication and add more if needed.
W
Warren BranchSep 12, 2025
What causes constant buzzing sound in EarthQuake VERSA 25780 Tiller?
- R
  Randall MyersSep 12, 2025
  If you hear a constant buzzing sound while the drive safety control lever is compressed on your EarthQuake Tiller, the following steps may help: * Properly space the wire guide from the idler pulley to clear the belt when engaged. * Adjust the engagement cable. * The belt may be stretched and needs to be replaced.