EarthQuaker Devices Dispatch Master

To Next Page

OPERATION MANUAL

<<< Power Requirements >>>

<<< Tech Specs >>>

• Current Draw: 78mA

• This device take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We

always recommend pedal-specic, transformer-isolated wall-wart power supplies or multiple

isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power.

Switching-type power supplies, daisy chains and non-pedal specic power supplies do not lter

dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!

• Input Impedance: 1M Ohm • Output Impedance: <1K Ohm

<<< Warranty >>>

This device has a limited lifetime warranty. If it breaks, we will x it. Should you encounter any

issues, please email info@earthquakerdevices.com.

www.earthquakerdevices.com

<<< Flexi-Switching >>>

This device features Flexi-Switch

™

Technology! This relay-based, true bypass switching style

allows you to simultaneously use momentary and latching-style switching.

• For standard latching operation, tap the footswitch once to activate the effect and then tap

again to bypass.

• For momentary operation, hold the footswitch down for as long as you’d like to use the effect.

Once you release the switch, the effect will be bypassed.

Since the switching is relay-based, it requires power to pass signal.

Need help?

Do you have a question about the EarthQuaker Devices Dispatch Master and is the answer not in the manual?

Summary

Flexi-Switching Technology

Momentary and Latching Operation

Explains simultaneous momentary and latching footswitch use and relay-based signal pass.

Power Requirements and Usage

Current Draw and Power Supply Recommendations

Details 78mA current draw, recommends isolated power supplies, and warns against higher voltages.

Technical Specifications

Input and Output Impedance

States input impedance is 1M Ohm and output impedance is <1K Ohm.

Warranty Information

Limited Lifetime Warranty

Outlines the limited lifetime warranty and contact information for issues.

Pro Tip

Reverb Repeats Control Function

Explains the secondary function of the Repeats control in Reverb-only mode for decay and tone.

Suggested Settings

Delay and Reverb Presets

Provides example settings for different musical styles like 120 BPM, Rockabilly Slap, and ambient tones.

Control Layout and Usage

Dispatch Master Controls

Details the function of Mix, Time, Reverb, and Repeats controls for delay and reverb effects.