EarthQuaker Devices Levitation

To Next Page

OPERATION MANUAL

<<< Power Requirements >>>

<<< Tech Specs >>>

• Current Draw: 72mA

• This device take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We

always recommend pedal-specic, transformer-isolated wall-wart power supplies or multiple

isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power.

Switching-type power supplies, daisy chains and non-pedal specic power supplies do not lter

dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!

• Input Impedance: 1M Ohm • Output Impedance: <1K Ohm

<<< Warranty >>>

This device has a limited lifetime warranty. If it breaks, we will x it. Should you encounter any

issues, please email info@earthquakerdevices.com.

www.earthquakerdevices.com

<<< Flexi-Switching >>>

This device features Flexi-Switch

™

Technology! This relay-based, true bypass switching style

allows you to simultaneously use momentary and latching-style switching.

• For standard latching operation, tap the footswitch once to activate the effect and then tap

again to bypass.

• For momentary operation, hold the footswitch down for as long as you’d like to use the effect.

Once you release the switch, the effect will be bypassed.

Since the switching is relay-based, it requires power to pass signal.

Need help?

Do you have a question about the EarthQuaker Devices Levitation and is the answer not in the manual?

Summary

Flexi-Switching Technology

Latching Operation

Describes standard latching operation by tapping the footswitch once to activate and again to bypass.

Momentary Operation

Describes momentary operation by holding the footswitch for desired effect duration.

Power Requirements

Current Draw

Specifies the current draw of the device as 72mA.

Voltage and Power Supply

Requires standard 9V DC with negative center barrel; recommends isolated supplies and warns against higher voltages.

Technical Specifications

Input and Output Impedance

Specifies input impedance as 1M Ohm and output impedance as <1K Ohm.

Warranty Information

Limited Lifetime Warranty

Details the limited lifetime warranty and provides an email for issues.

Controls Overview

Mix Control

Controls the blend of wet and dry signals, with more reverb clockwise.

Length (Toggle)

A toggle switch that sets broad decay time, shorter to the left, longer to the right.

Decay Control

Controls the length of the reverb decay, longer clockwise.

Tone Control

Adjusts bandwidth for the reverberated signal, affecting low-end content.

Atmosphere Control

A harmonic regeneration control that feeds upper frequencies back for ringing reverb.

Suggested Settings

Reverb Sound Examples

Offers example settings for various reverb sounds like Empty Stage, Open Air, Psychedelic Surfer, and Starchild.

Suggested Placement