Customer/Warranty Service: (866) 446-2864
Page 17
ComfortZone
™
Heater Specifications
ModelCZ1500‐W—WoodCabinet
• Cabinet:¾ply—Cherry,Oak&Tuscan
Mahoganyveneersavailable
• Weight:36.0lbs
• Dimensions:15½”x15½”x17”(H,W,D)
• PowerRequirements:115VoltAC,1000Watt
(Model1000),1500Watt(Model1500)
• PowerCord:7ft—14gauge.
• Thermostat:ElectronicAnalog—largenumbers.
• Accuracy:±2°(1degreeupand1degreedown)
• DelayedStartFunction:Upto24hours
• SafetyCut‐Off:Yes.
• ListedApprovals:CTUV‐US&International(ULEquivalent).
• RemoteControl:Creditcardtype—largebuttonsurface
• Pre‐Filter:Life‐timeelectrostatic
• CordStorage:ConvenientCordWrapfortransport&storage
• LifetimeElectrostaticFilter:tomaintainairquality,whichisremovedandinstalled
withaspring
• HeatType:TherapeuticQuartzInfraredHeat.
• HeatChamber:Copper‐iongenerationpanelwithstainlessdiffractioncoils.
• HeatingElements:Four(4)quartzinfraredemitters.
• EmitterLifeExpectancy:Ratedat20,000hours.
• FanSystem:Singlehigh‐outputscrollfanorTwinDC90mmball‐bearingfans.Both
systemsprovidemuchquieteroperationandeliminatevibration&ELF60Hz
electromagneticemissionscausedbyACaxialfanmotors.
• FanNoiseLevel:42dB—quiet.
• Warranty:Limited3‐YearWarranty.
CZ1500‐Wood
©2008 EarthWise Electronics, Inc
Page 10
To assure maximum performance of your ComfortZone™ heater, please
reviewthefollowingrecommendations:
• Do not locate the heater in an area with a high a high air exchange rate in
andoutoftheroom.Heatproducedshouldbecontainedintheroom.
• Try placing the heater near a warmer inside wall and direct the output
toward a cooler outside wall. The cooler outside wall will tend to draw the
generatedheattowardsit,whichwillallowformoreefficientheating.
• Placingtheheaternexttoacoldairreturnwilldrawtheheatawayfromthe
areatobe heated.Tryclosingorcoveringthecoldairreturn.Thiswillallow
formoreefficientheating. Experimentwith the placement ofthe heater to
seewhatworksbestforyou.
• To ensure maximum efficiency, a 30% minimum relative humidity should be
maintainedintheheatedenvironment.Thisisusuallynotaconcern.
• The heater is designed to operate for maximum efficiency in the 68‐74
degree range. Due to the soft heat concept, as explained earlier,
temperaturesat68degreesFfeelasthoughitwere72degreesF.Thisisdue
totheheatmixingwithhumidityevenlyforhead‐to‐toecomfort.
• When the heater is placed in an isolated area, i.e. basement or recreation
area,anyexistingHVACheatingsystemventsshouldbeclosedinthatarea,
if possible. This allows the heater to maintain the isolated area more
efficiently.
• Ifplacingtheheaterafewfeetabovethefloor,suchasinroomswithlarge
areas of bare concrete, make sure the heater is secure and won’t fall. This
will allow for more efficient heating since concrete acts as a heat sink and
willtendtodrawtheheatinitsdirection.Optimall
y,concretefloors
should
becoveredtoprovidesomeinsulationfactorfromtheconcrete.
• Setyourcentralheatingsystemtoalowertemperature.Placetheheaterin
the area you spend the most of your time. Now set the heater to your
comfortlevel. There is no point in heating multiple rooms to68+degreesF
whennotinuse.
• Whenheatinglargerareas,placetheheaterinacentrallocation.
• If the heater is used in an extremely dirty or dusty area, the filter must be
cleanedmorefrequentlytomaintainheaterperformance.
Suggestions for Best Performance
To Next Page
Loading...