EAS Electric E300WHF - Operating Instructions; Timing Settings; Timing Cancelling; Weekly Timing Setting

setting, press the button to exit the setting.
Remarks：
(1) If no operation for 30 seconds, the setting will automatically exit with failure;
(2)Press the button to complete the setup and exit;
(3) If the error is found in the previous setting, the user can press the button before completing the setting to switch
the hour and minute setting.
(4) After the date is completely set, the system automatically determine the current date is what day in a week.
(5) Press the and
button at the same time, and query the date. First the year is displayed, and the month and
day are displayed after 2 seconds.
5. Timing setting
Press and hold the
button 3S to enter the timer setting, the specific method is as follows:
Timing 1：When "1" light is on, enter into "timing 1 opening" setting. The "hour" light will flash, the user can press
button to adjust the hour. After adjusting, press theor button, the "minute" light will flash, the user can
orpress button to adjust the minute. If pressing the button again, it will enter into "timing 1 closing"
setting, the setting way is the same " timing 1 opening" .
Timing 2: The user press the
button again, the light "1" is out, and light "2" is on, it will enter into "timing 2
opening" state, the setting way is the same "timing1".
Timing 3: The setting way is the same as "timing 1" and "timing 2".
If no any button pressed in 30 seconds, then automatically quit from the setting. The settings are invalid.
button for 3 seconds, then the setting is done and quit from the
During the setting process, hold and press the
time setting.
6. Timing cancelling
Method 1: After timing setting successful, the user can hold and press the and buttons at the same time for
3 seconds, the timing setting is cancelled. The light that represent the timing setting successful will be out.
Method 2: The user can set the timing on and off of the corresponding time period to the same time according to the
timing setting method.
7. Weekly timing setting
This timing function is circulated timing. After successful setting, the unit will run at the set time every day. The user
can set up the time of starting and closing on a daily basis according to need, and can also determine the switch time of the
specific day in a week according to need.
V.2
47