3
Intended use
This product is intended solely for charging electrically
powered vehicles equipped with non-gassing batteries
(e.g. lead-acid batteries).
The product shall only be used with a charging cable
according to IEC 62196. The product must be firmly
mounted on a wall or structure that covers the entire
back side of the product and has a sufficient load-
bearing capacity. It may only be operated with the
approved operating parameters and under the specified
environmental conditions (see page 6).
Uses other than those specified here are not permitted.
Conventions
This symbol indicates that the respective
instructions must only be carried out by an
authorised electrician.
This symbol indicates an immediate danger to
life and health of individuals due to the effects
of electrical energy. Non-observance of these
instructions will result in serious damage to
health – up to and including life-threatening
injuries.
Introduction
To Next Page
Loading...
