Need help?Do you have a question about the Eastwood MIG 175 and is the answer not in the manual?
General| Welding Processes | MIG (GMAW), Flux Core (FCAW) |
|---|---|
| Input Current | 20 Amps |
| Output Current | 175 Amps |
| Input Voltage | 220V |
| Welding Current Range | 30-175 Amps |
| Weldable Materials | Mild Steel, Stainless Steel |
| Wire Size | 0.023 in. - 0.035 in. |
| Spool Size Capacity | 4 in. or 8 in. |
| Weld Thickness | Up to 5/16 in. (single pass) |
Details the duration and scope of the limited warranty.
Outlines steps for obtaining warranty service and repair.
Specifies what is not covered and limitations.
Lists output, input, duty cycle, dimensions, and weight.
Details compatible wire types and diameters.
Covers arc dangers, electrical code compliance, and disconnect procedures.
Essential precautions to avoid electric shock.
Specific notices for safe installation, maintenance, and operation.
Connects the MIG torch assembly to the welder.
Attaches the ground clamp for electrical circuit completion.
How to change polarity for solid wire vs. flux-cored.
Instructions for connecting the gas bottle, regulator, and hose.
Guides fitting 4" and 8" wire spools with tension adjustment.
Specifies power requirements (220 VAC, 30 Amp).
Step-by-step process for feeding wire through the drive motor.
Setting the correct CFH for optimal welds.
How to swap rollers for different wire diameters.
Connects the spool gun to the welder.
Guides feeding wire using the spool gun assembly.
Detailed instructions for performing a weld from setup to completion.
Illustrates and describes common types of weld joints.
Specific methods for welding thin gauge metal.
Techniques for welding thicker materials.
Explains the welder's thermal and circuit breaker protection.
Addresses common problems like lack of penetration and burn-through.
Provides tips to prevent warping and improve tack welds.
Solutions for poor fusion, porosity, and excessive spatter.
Lists consumables, optional parts, apparel, and contact info.
To Next Page
