Easy Clocking XENIO 500 - Enrolling Users (Fingerprint, Card, PIN); Software-Based User Setup

Enrolling Employee Fingerprint
Card or Pin Code
To enroll a User on the Xenio Smart Clock, you must
first create the User in the EasyClocking software.
In your EasyClocking software:
1. Click on the Users tab, then click on the General tab.
2. Click on the Create User button located to the right
of the screen.
3. Enroll the User with their corresponding settings.
4. Assign the User to the device via the
Clocking Permissions
Once the User has been successfully enrolled within the
software, we can send the Clocking Permissions. Pushing
this command will send the User’s full name from the
software to the Time Clock.
Note:
The Time Clock(s) must be connected to a network in order to
receive any commands from the Software.
Enter the Xenio Time Clock’s menu
1. Select Users.
2. Select the User from the list on the left. You may also
search for a specific User by tapping on the Search
Box at the top of the list.
16