Easy Vac PM60 - Procedure Completion and Canister Care

6
8. Connect one end of the Patient Suction Tubing to the port on the
Canister marked Patient Tubing.
9. Connect the other end of the Patient Suction Tubing to the
suction catheter and begin procedure as instructed by Provider.
10. When procedure is completed, press the On/Off Switch to the
“OFF” position.
• DONOToverfillthecanister
11. Empty the Suction Canister as follows:
• Removethecanisterfromitsbracketandemptyasdescribed
by your Healthcare Professional or Healthcare Facility
protocol.
CAUTION
Canister is for single patient use only.
12. Replace Suction Canister and reconnect all suctioning tubing.