Easy Vac PM60 - Operating Instructions; Setup and Initial Use; Vacuum Adjustment and Operation

5
OPERATING INSTRUCTIONS
CAUTION
Inspect the Easy Vac Aspirator for visual damage, DO NOT USE
if damaged.
1. Place Easy Vac Aspirator near electrical receptacle on a table,
floor or other horizontal, smooth, hard surface.
Allow a minimum of 4 in. (10 cm) clearance on all sides to ensure
adequate air flow for cooling of Aspirator.
2. Press down on Aspirator until Suction Feet are secure.
3. BesuretheOn/OffSwitchisinthe“OFF”position.
4. Be sure the Inline Hydrophobic Filter is properly connected to the
vacuum port on the Suction Canister lid.
• TheInlineHydrophobicFilterpreventsliquidfromentering
the vacuum pump.
CAUTION
DO NOT run the Easy Vac Aspirator without Inline Hydrophobic
Filter. This will void the warranty.
5. Plug the Aspirator into receptacle.
6. TurntheOn/OffSwitchtothe“ON”position.
7. Block the patient connection on the Suction Canister and adjust
the Vacuum Control Knob to the desired vacuum.
To INCREASE vacuum - Turn knob CLOCKWISE
To DECREASE vacuum - Turn knob COUNTERCLOCKWISE
• VacuumshouldbesetasprescribedbyProvider.