How to troubleshoot Easy Vac Medical Equipment aspirator that will not operate?
If your Easy Vac Medical Equipment aspirator isn't operating, first ensure the On/Off switch is in the “On” position. Also, verify that the power cord is properly connected to the outlet. If the thermal limit has been exceeded, shut the aspirator off, wait 15 minutes, and make sure the vents are clear.
What to do if there is no vacuum on gauge / no vacuum at Patient Connection Tubing in Easy Vac PM60?
If there's no vacuum on the gauge or at the Patient Connection Tubing of your Easy Vac Medical Equipment, check if the Hydrophobic Filter and Suction Canister are connected and tightened properly. If the Suction Canister is defective, replace it. If the regulator is defective, contact your Provider.
What to do if vacuum on gauge / no vacuum at Patient Suction Tubing in Easy Vac Medical Equipment?
If your Easy Vac Medical Equipment shows vacuum on the gauge but not at the Patient Suction Tubing, the hydrophobic filter may be clogged and needs replacement, or the canister might be overfilled and needs emptying.
Why am I unable to adjust vacuum on Easy Vac PM60?
If you are unable to adjust the vacuum on your Easy Vac Medical Equipment, the regulator may be defective. Contact your Provider.
What to do if no vacuum on gauge / vacuum at Patient Connection Tubing in Easy Vac PM60 Medical Equipment?
If there is no vacuum on the gauge but vacuum is present at the Patient Connection Tubing of your Easy Vac Medical Equipment, the vacuum gauge may be defective. Contact your Provider.
Imminent hazards that can result in death or serious injury if not avoided.
Potentially hazardous situations that can result in death or serious injury if not avoided.
Potentially hazardous situations that can result in minor or moderate injury if not avoided.
Physical size, weight, and shipping weight of the Easy Vac Aspirator.
Voltage, frequency, amperage, and operating/storage temperature ranges.
Details on safety classifications like Class II, Type BF, and IPX0.
Steps for placing, securing, connecting the filter, and plugging in the aspirator.
Connecting tubing, adjusting vacuum control, and starting the device.
Turning off the device, emptying the single-use canister, and reconnecting tubing.
Instructions for replacing the non-cleanable filter assembly.
Procedure for cleaning the external parts of the aspirator with soap and water.
Guidelines for disposing of bio-waste products and consulting professionals.
List of available replacement parts with their corresponding part numbers.
General| Brand | Easy Vac |
|---|---|
| Model | PM60 |
| Category | Medical Equipment |
| Language | English |
To Next Page