EasyManua.ls Logo

Easy2Access Easy-903 G2 - User Manual

Easy2Access Easy-903 G2
24 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Brugervejledning for
Easy2Access A/S’ kodelås
Easy-903 G2
Manual for Easy2Access A/S
Pin code lock Easy-903 G2
Easy2Access A/S
Slotsgade 63
3400 Hillerød
Tlf 70237032
www.easy2access.net
www.e2a.net

Questions and Answers

  • D
    Dawn BrandtAug 3, 2025
    Why is my Easy2Access Easy-903 G2 Door locks beeping?
    • B
      Brittany PorterAug 3, 2025
      Your Easy2Access Door locks might be beeping because it's time to change the batteries. Try using good quality alkaline batteries. If replacing the batteries doesn't solve the problem, it could indicate a defect in the electronic unit, and you should seek assistance from your local Easy2Access A/S agent.
  • M
    Micheal AndersonAug 10, 2025
    What to do if Easy2Access Easy-903 G2 cannot open after entering the PIN?
    • B
      brandilucasAug 11, 2025
      If your Easy2Access Door locks won't open after entering the PIN, it could be due to several reasons: * **Low power:** Try changing the batteries. * **Clutch issue:** There might be a problem with the clutch. Contact your local Easy2Access A/S agent. * **Electronics failure:** There could be a failure in the electronics. Contact your local Easy2Access A/S agent. * **Spindle Misalignment:** Ensure the spindle is correctly installed to the proper mark.
  • A
    Alexandra LopezAug 17, 2025
    How to fix Easy2Access Easy-903 G2 Door locks that won't lock?
    • O
      Olivia HensleyAug 17, 2025
      If you cannot lock your Easy2Access Door locks, consider these potential causes: * If the door is set to the open position with the key, it will remain constantly open. To resolve this, turn the key either a ¼ turn (for new locks) or 3-4 turns (for older locks) until the lock is in the locked position. * The lock might be coded to remain in a constant open position. To change it to automatic locked position, press: # 1 master code # 0.
  • M
    Michelle GravesAug 26, 2025
    Why are the handles on my Easy2Access Easy-903 G2 Door locks so tight?
    • N
      ncastroAug 26, 2025
      If the handles on your Easy2Access Door locks are too tight, it could be because: * The spindle does not match the door thickness. In this case, use a new lock whose spindle matches the door thickness. * There’s a declination for the fixing holes. You should adjust the location of the fixing holes.

Summary

Preface

Parts in the Packaging Box

Required Tools

Pre-installation

Sizing Spindle

Installation

Installation of the outside unit

Guides the attachment of the external lock components.

Installation of the inside unit

Guides the attachment of the internal lock components.

Final inspection;adjustment prior to setup and use

Outside Unit Programming

Adding the pin codes

Sets new user or master PIN codes for the lock.

Deleting the pin codes

Removes existing PIN codes from the lock.

Unlocking from the Outside Unit

Opening the lock with key

Explains using the physical key for emergency access.

Resetting the lock

Locking of a multipoint mortise

Generation of a key”;pin code far away from the lock

Maintaining the Lock

Changing batteries

Troubleshooting

Easy2Access Easy-903 G2 Specifications

General IconGeneral
Power SourceBattery
MaterialZinc Alloy
IP RatingIP54
Battery TypeAA Batteries
Battery Life12 months
Unlock MethodsMechanical Key