EasyManua.ls Logo

EasyCook 727e - Cleaning Your Easycook

Default Icon
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CLEANING YOUR EASYCOOK
Light Cleaning - Bowl (the bowl sits in the frame only and is not attached to the frame)
Unplug oven and allow to cool.
Using a sponge or dish cloth with mild detergent and warm water
wipe glass bowl clean.
Rinse well to remove all detergent.
Easy Clean Function Bowl
(the bowl sits in the frame only and is not attached to the
frame)
To use the Easy Clean function; fill with approximately 10cm of warm
water.
Add a teaspoon or squirt of mild dishwashing detergent.
Submerge cooking wire racks in water for soaking.
Replace lid and plug in. Push safety handle down.
Set timer to 10 minutes.
Select “WASH” on the temperature control panel or a very low heat.
After cycle is completed, empty then rinse in warm water to remove
all soap residue. Remove stubborn food spots with nylon scourer and
a crème paste cleanser if necessary.
Take care when drying the bowl to avoid dropping.
Cleaning Fan Guard
Remove the fan guard by removing the screws with a “Phillips Head”
screwdriver.
Place the fan guard in soapy boiling hot water and let soak or boil on
stove for 15 minutes.
Remove from water and scrub with stainless steel pad.
Cleaning Lid Top
Use a little gumption or crème paste and a steel wool pad to clean
the glass rim.
IMPORTANT:
Always unplug your oven before cleaning.
Let oven cool before washing
Never immerse lid in water.
Do not wet fan assembly
Take care not to splash or spill liquid into the motor part area.
WARNING: DO NOT POUR COLD WATER INTO A HOT BOWL OR
BOILING WATER INTO COLD BOWL AS THIS MAY CAUSE
UNDUE STRESS TO THE GLASS BOWL.

Related product manuals