Need help?Do you have a question about the easydriver basic 1.8 and is the answer not in the manual?
General| Logic voltage | 5V |
|---|---|
| Current per Phase | Up to 750mA |
| Microstepping | Yes |
| Step Angle | 1.8 degrees |
| Supply voltage | 7V to 30V |
| Maximum drive current | 750mA per phase |
| Microstep sizes | 1/2, 1/4, 1/8 |
| Interface | Step/Direction |
| Protection | Thermal shutdown, overcurrent protection |
Details on turning the remote control ON/OFF.
Critical precautions for operating and maintaining the easydriver safely.
Guidance on selecting the correct mounting location for the drive unit.
Steps for attaching the frame and clamping plates to the chassis.
Procedure for fitting the stabiliser rod between drive units.
Instructions for aligning the drive units to the chassis.
To Next Page
