Appendix A1
Synchronisation must be performed in the event of a
functional fault or following the exchange of electronic
parts. Proceed as follows:
The synchronisation is completed.
The remote control will switch OFF after approx. 60
seconds when no input is provided!
Switch OFF the remote control
(= press once) as required
GB11
Switch ON the remote control (= press 2x)
Keep the forwards AND backwards button
pressed during the self-test. A constant
sound signal is produced and the trailer
symbol of the remote control flashes.
The sound signal goes off and the trailer
symbol lights up permanently once syn-
chronisation has been completed. Release
the forwards and backwards buttons. A
short sound signal is produced. The base
station and the remote control are now
synchronised with each other.
Trailer battery LED, red
Symbol not lit up: Battery voltage is in
order
Slow flashing: Batteries should be
charged
1x per second, continuous flashing and 3x
acoustic warning: Batteries almost empty.
Charging is essential!
LED permanently on and 10x acoustic
warning: Batteries deeply discharged. The
battery should be charged as soon as
possible, so that it does not get damaged.
Temperature indicator LED, red
Symbol not lit up: Temperature of the base
station is in order
Symbol rapidly flashing and 5x acoustic
warning: Temperature of the base station
too high. All driving functions are switched
off. Let the base station cool down! The
system can again be switched on once the
base station has cooled down.
Overload indicator LED, red
Symbol not lit up: Current flow through the
base station is in order
Symbol permanently lit up and acoustic
warning: Overcurrent detection. All driving
functions are switched off. Reactivate the
system by switching the remote control Off
and On.
Radio range indicator LED, red
Symbol not lit up: Radio range is in order
1x per second flashing: Radio range ex-
ceeded. All driving functions are switched
off. Reactivate the system by switching the
remote control Off and On.
Switch off the base station as well.
A1 Synchronisation
Switch on the base station.
English
To Next Page
Loading...