C.If there is chip immobilizer in your vehicle factory key fob, you should add an extra bypass module,
please make sure the bypass module is well installed so that you can start your vehicle.
D.The start time is not enough. If your car is diesel car need a longer engine starting/cranking time (more
than 3 seconds), you can turn on ON dashboard first then wait for a few seconds to pre-warm the spark
plug, then start the car or add an extra timer delay switch.
The hand brake should be in neutral position when use the remote start function.
FAQs of Ec003
Dear Customer,
There are possible 4 reasons:
2.I am not able to use remote engine start function, what's the reason?
a.Please check if the green fuel pump wire in 10 Pin wire harness is correctly connected. For wiring
method of this wire, please refer to Note 11 fuel pump wire in the user manual.
B.Please check whether the 6P ignition wire harness are well connected or not, especially the ignition
wire & starter wire.
1.When I attempt to start the vehicle, it starts but shut off a few seconds, what's the reason?
b.Please check whether the gray hand brake wire is well connected. For automatic gear car, the gray
hand brake wire should connect with chassis ground; for manual gear car, this wire should connect with
hand brake wire in the car.
c.When use remote engine start function, please keep a distance at least 5 meters away from the car as
you can't use remote engine start function when in PKE induction range.
4.Is there a GWR (ground while running) wire? Or how to connect with a GWR wire to the alarm?
Please refer to note 9 GWR (Ground while running) (-) wire connection
A.The green fuel pump wire in 10 Pin wire harness is not connect well & which lead there is no electricity
when you want to start the vehicle. For wiring method of this wire, please refer to Note 11 fuel pump wire
in the user manual.
Thank you for purchasing our products. Here is some FAQs for your reference, if there is question when
install/ use the products, we recommend you to read the FAQs to find answer and solutions. If those
FAQs still not able to help you fix the problem, you can also contact us and we will help you till everything
is working well.
5.How to connect a window closer module with your alarm?
If there is window closer module need to connect with EC003 alarm, connect the wire from window closer
module with white/black locking wire in central door locking wire.
3.How to do programming?
Please refer to programing method in the user manual.
7.The PKE function sometimes work sometimes not work, why?
The problem should due to the blue door trigger wire (-) not well connected.
6.I turn on PKE function then start the car, but when I stop and cut off the engine, the PKE
function is automatically turn off and I have to turn it on again, what's the reason?
It should due to the PKE antenna not mount well lead there is PKE induction blind spot, if so, please
adjust the PKE antenna mount position to get a maximum PKE induction range. You can refer to PKE
antenna mount position in user manual to mount the PKE antenna position till you get a maximum PKE
induction range.
The quality of this product is strictly controlled before out of the factory, which ensure its well performance
under normal utilization. EASYGUARD electronics provide 1 year quality guarantee. If there is any failure
due to product quality issue, please contact us for free repair or replacement. Any incorrect
operation/installation/using lead the product failed to work is not in cover of free quality guarantee service.
This device can improve the vehicle safety level, but could not prevent the vehicle from being stolen or the
occurrence of unexpected accidents. EASYGUARD Electronics will not be liable for any resulting from the
damage of this product cause by direct or indirect losses.
IMPORTANT:
Warranty information
-26-
© EASYGUARD Electronics. All right reserved.
-25-
© EASYGUARD Electronics. All right reserved.
To Previous Page
Loading...