Choose a channel
This device has multi Channels for communicating with others.
To choose one：
1．In Communicator Mode or Watch model, press the menu key briefly a key beep
tone is locally generated and the Channel number on the LCD Display will
flash.
2．Press the Up or Down key to reach higher or lower Channels.
3．Auto-repeat is engaged by pressing and holding either the Up or Down Key,
you’ll hear a standard key beep with each channel change.
4．To exit the Menu, press the Red Button.
Channel Scan
To scan the whole channels of the Communicator for any activity:
1．Press the Scan key. Once engaged, the unit will start to rapidly scan the whole
channels of the communicator for any activity. The unit will pause on an active
channel for 4~5 seconds before resuming Scan function.
2．To exit the Scan mode, press the Red button.
Transmitting and Receiving
To use your communicator to communicate with others:
1．In Communicator Mode, the unit is continuously in RECEIVE mode.
2．Press and hold the Red Button and speak as you normally would, holding the
microphone about 2~3inches away from your mouth.
3．When you finished speaking, release the Red Button. You are now ready to
receive incoming transmissions. While receiving transmission, the RX icon
appears on the display.
Sending a Call Alert Tone
To send a Call Alert Tone, Press the Red Button<PTT/CALL> twice in a rapid
To Next Page
Loading...