To Next PageTo Next Page
Need help?Do you have a question about the EasyPro Prelude and is the answer not in the manual?
General| Brand | EasyPro |
|---|---|
| Model | Prelude |
| Category | Water Dispenser |
| Language | English |
Position your filter falls where you want the waterfall or stream to originate. Excavate the pond to the desired depth.
Ensure the ground is level around the pond perimeter and the filter falls box area. Compact the soil under the filter.
Thread the 2" male adapter and 2" plug into the filter ports using Teflon tape or silicone.
Glue the PVC flex pipe into the male adapter and hold until the glue sets.
Set the filter box on the prepared surface, ensuring it is level side to side and tips forward.
Insert PVC support tubes into notches or use built-in supports for stability.
Run underlayment in the pond and up to the filter box. Lay the liner over the underlayment, working out wrinkles.
Fold the liner over the Spliner Lock and secure with the Spliner Bar and Spliner Locks.
Lay filter mats and Bio-Blox media bags in the bottom of the filter box.
Cover the filter box with a flagstone or cover, and stack stones to conceal the box and liner.
Clean Bio-Media by agitating it in the filter and draining dirty water. Be cautious of chlorinated water.
Clean filter mats by spraying them off with a garden hose.
