Eaton 1 Series - Lip Seal Installation Procedure

26
End Cover
Figure 36
101 Holding the valve plate in place carefully install the
end cover.
Note: Use petroleum jelly to help hold the valve plate to
the end cover.
102 Install the eight end cover bolts, remember the
shipping strap.
103 Tighten the end cover bolts evenly so the Cylinder
barrel spring pre-load is taken-up gradually. Torque
them alternately to the specifications given in the table
below:
Valve
Plate
Bearing
Plate
Dowel Pins
Figure 35
96 Install two dowel pins in the holes in the cylinder
barrel face.
97 Place the bearing plate on the cylinder barrel and
engage it with the dowel pins.
98 Liberally lubricate the bronze surface of the bearing
plate with clean hydraulic fluid.
99 Install the last dowel pin in the hole in the end cover.
100 Place the valve plate on the end cover. Be sure it
engages with the dowel pin.
End Cover, Valve Block and Control Valve
Model Number
End Cover Bolt
Torque
33, 39 39 lb-ft [53 Nm]
46, 54, 64 63 lb-ft [85 Nm]