Eaton 50 VCP-TR16 User Manual (English)

Questions and Answers:

C
Courtney GoodwinAug 9, 2025
Why does my Eaton 50 VCP-TR16 circuit breaker keep opening?
- J
  Jessica ChanAug 9, 2025
  If your Eaton Other circuit breaker undesirably opens, it could be due to several reasons: * The undervoltage release may be operating because the voltage is too low or zero. In this case, check and correct the UVR supply voltage to be within 85-110% of the rated voltage. * The shunt trip might be operating. Inspect the control signal(s) to the shunt trip and correct if necessary. * The trip latch could be defective. Inspect the latch condition and engagement before closing.
D
Dr. Tracy BrooksAug 19, 2025
How to fix Eaton Other circuit breaker that won't close remotely?
- H
  harry79Aug 19, 2025
  If your Eaton Other circuit breaker can be closed locally but not remotely, here are some possible reasons: * The spring release (closing) coil supply voltage might be low, or the spring release itself could be faulty. Check the power supply voltage and replace the spring release if necessary. * There might be a secondary contact wiring problem. Ensure that the electrical pin and socket connectors are properly seated in the molded plug and verify the wiring. * The latch check switch could be open, either due to a bad switch or because it hasn't been reset.
T
thomasrachelAug 25, 2025
What to do if Eaton 50 VCP-TR16 Other circuit breaker won't open remotely?
- E
  erica20Aug 25, 2025
  If your Eaton Other circuit breaker can be opened locally but not remotely, consider the following: * The shunt trip control signal might be absent or too low. Check that the supply voltage exceeds the minimum of the voltage range when a signal is applied to the shunt trip. * The shunt trip could be faulty or improperly installed. Remove the front cover and check the voltage supplied to the shunt trip. Ensure the shunt trip is correctly seated and the retainer is snapped into place. Check for shunt trip motion; replace the shunt trip if it's faulty. * A secondary contact wiring problem might exist. Make sure the electrical pin and socket connectors are properly seated in the molded plug and verify the wiring.
M
morrisonannaAug 29, 2025
Why Eaton Other circuit breaker won't recharge electrically?
- C
  Christine EscobarAug 29, 2025
  If your Eaton Other circuit breaker recharges manually but not electrically, it could be due to: * Absent or low charging motor supply voltage (below the minimum range). Check the charging motor electrical circuit voltage, ensuring you check it under load. * A faulty charging motor. Consider replacing the charging motor assembly.
D
Daniel Collins MDSep 3, 2025
How to unlock Eaton Other circuit breaker that won't open locally?
- J
  James Lutz PhDSep 3, 2025
  If your Eaton Other circuit breaker cannot be opened locally, it might be because the OPEN pushbutton is locked. If so, remove the lock.