Instructional Literature
Page 34 Effective: May 2008
Instructions for the FP-6000 Protective Relay
For more information visit: www.eaton.com IB02602004E
Display 11. View Settings.
Display 12. System Control Display.
Display 13. Motor Config Display.
Display 14. CT & PT Config Display.
Display 15. Direction Config Display.
System Config
System Control
Motor Config
CT & PT Config
Direction Config
Display Display Meaning
Frequency 60 Frequency
Phase Seq ABC Phase Sequence
Tem p U nit °C
Prim Units No Primary Units
I/O Config Default Input/Output Configuration
Prog Logic Default Programmable Logic
Remote Set Disable Remote Set
Prg w/Brk Either Program with Breaker
Remote Brk Disable Remote Breaker
# Set Grps 1 Number Setting Groups
Set Ctrl Local Set Control
Disarm Ctrl Disable Disarm Control
Energy Unit kWh Energy Unit
TOC Reset T 5 Time Overcurrent Adjust Time
Bkr Oper PB Disable Breaker Operation Pushbutton
Display Display Meaning
ThermI Type RMS Thermal Current Type
Therm Model User Thermal Model Type
I2 Multi K 6.0 Negative Sequence Current Multiplier
FLA 500 Full Load Ampere
LockRotor I 300% Locked Rotor Current
MaxStall Tc 1 Maximum Allowable Stall Time in Seconds
Service F 85% Service Factor
Cooling Tc 100 Cooling Time Constant in Minutes
MaxTemp Trl 240 Maximum Temperature Rise Over
Ambient in °C
NormTemp Tro 60 Normal Temperature Rise Over Ambient
in °C
Ambient 40 Normal Ambient Temperature in °C
Display Display Meaning
CT Connect 3-wire CT Connection
PH CT Ratio 500:5 Phase CT Ratio
IX CT Ratio 500:5 Ix CT Ratio
VT Connect Wye Voltage Transformer Connection
VT Ratio Exp VT Ratio Decimal Place
Main VTR 100 Main Voltage Transformer Ratio
Aux VTR 100 Auxiliary Voltage Transformer Ratio
VT Sec Rating 69.28 Voltage Transformer Secondary
Rating
Display Display Meaning
Line Z1 Ang 70 Positive Line Impedance Angle
Line Z0 Ang 70 Zero Line Impedance Angle
PhDirVmin Phase Direction Minimum Voltage
IR Dir Cntrl OFF IR Direction Control
3V0 Source Calc Zero Sequence Voltage Source
3I0 Source Calc Zero Sequence Current Source
IX Dir Cntrl OFF IX Ground Direction Control
To Next Page
Loading...
