2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
177
TRSM0940 Disassembly and Assembly | VCS/VMS Combination Cylinder
3. Install a new gasket on the Range Cylinder Housing
Mounting Surface and Install the Cylinder housing into
the Auxiliary Case Housing.
4. Lean the Auxiliary section back with the Range Cylinder
upward. Insert the Range piston with flat side to rear.
Push it as far back as far as it will go.
5. Secure the Range piston with the 15/16” retaining nut,
torque to 70-85 lb-ft (94.91-115.24 N•m).
6. Insert the Reduction piston with flat side to rear. Push
it as far back as far as it will go.
7. Secure the Range piston with the 3/4” retaining nut,
torque to 50-65 lb-ft.
Note: If reusing existing nut, make sure the nylon lock-
ing material is in good shape. Replace if not.
To Next Page
Loading...