2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
61
TRSM0940 Auxiliary Section Service Procedures | VCS/VMS Auxiliary Section Assembly and Installation
11. Install the six (6) retaining capscrews in the non-cham-
fered holes on the rear bearing cover. Torque to 35-45
lb ft.
12. Install the Auxiliary Countershaft Bearing Races.
13. Install the Auxiliary Countershaft support straps,
RR1002TR, with 2 – 3/8”NC x 1” and 1 – 3/8” NC x 2
½” clean capsrews
Note: Do not torque with an air gun. Tighten only to
hand tight.
14. Apply lube to the o-rings on the Combination Cylinder
and the yoke bars for the Range and Reduction.
15. Position a new gasket on the Combination Cylinder
mounting surface. Install the Combination Cylinder.
16. Apply lube to the Range and Reduction pistons. Install
the pistons into their respective cylinders in the
Combination Cylinder.
To Next Page
Loading...