Eaton FS-6105 - Page 45

REASSEMBLY - TRANSMISSION
4,
-
Using a sleeve type driver Insta ll rear malnshaft
bearing as shown
5. Reposition mainshaJt in vi$e with fr ont ol m:.
sha ft fac in g up. lub ric ;a le fricti on surface with
lransmisslon lube and in sta ll 1st speed synchroni·
zer .
••
••
6. Lubricate and lnstaJI 1s t goar bearings and spacer
( lnse1 ). Install 1st gear, clutching 1ee1h facing
down.
7. Install localing ball and \Va.sher. Washer can be in·
stalled either we.y . Insta ll snap ring as shown {In·
.. . ).