Eaton FS-6105 - Installation - Shifting Controls; Shift Bar Housing

INSTALLATION-SHIFTING CONTROLS
S h ift Bar Ho u sing
-- --,
...
... , ,, .. ,
1. Place transmission in neutral (i nset) end l ns1a ll
gasket on case. Place shift bar housing. In neutral
and In sta ll on case meking sure shift yokes allgn
with corresponding synchron i zers and s li di ng
clutch.
I•·•
2. Apply L octite 262 to thread$ o f capscre\vs. Install
two capscrew$ into a li gnment holes of shlfl bar
housi ng and torque to 20·25 lbs. ft C27·34 Nm).
••
•
"4
3. Install remaining capscrews and torque lo 20-25
lbs . ti (27·34 Nm).