Eaton i-on User Manual

i-on40 & i-onEX Range 4. Administration
Page 71
System Configuration
The System Configuration option allows you to change some parts of the
system to suit your particular needs. If you need more extensive changes
to the operation of the system then you must contact your installer.
Switching the Chime On/Off
The installer may have set up your alarm system to give a chime tone
whenever something triggers one or more detectors while the system is
unset. If you wish to switch this feature off (or on) then:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The bottom line of the display
shows:


6. Press  .
The bottom line of the display
shows the current status of the
Chime facility: “On” means the
loudspeakers will sound a chime
tone every time a detector with the
“Chime” attribute is triggered.


7. Press .
The status of the Chime facility changes
each time you press .


8. Press  when you have finished
making changes.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:



Eaton i-on Specifications

General

Brand	Eaton
Model	i-on
Category	Security System
Language	English