Eaton i-onG2SM - Page 60

User Menu Options
Page 56
HUA Function Enables or disables the ability for remote controls to
generate Hold-Up Alarms (HUAs).
These options are described next.
Editing the programming of the buttons
You can use System Config – Remotes – Edit to re-program the A, B or *
buttons on a one-way remote control, or the “*” button on a two-way remote
control, after the devices have been assigned to a user.
A button can be programmed to:
 Set a selected part set (in a partitioned system, it part sets only the
partition the remote control is assigned to).
 Operate an output configured as "User Defined" by the installer.
 Full set the whole system (one-way remote control only).
 Unset the whole system (partitioned system, one-way remote control
only).
 Full set or part set selected partitions (partitioned system, one-way
remote control only).
 Unset selected partitions (partitioned system, one-way remote control
only).
Note for one-way remote controls:
 If you have a part-setting (non-partitioned) system, you cannot
reprogram the unset button.
 If you have a partitioned system, the unset button can only be used to
unset some or all partitions allocated to the user. See Unset, Unset All
and Unset, Partitions below.
To re-program the buttons on a remote control:
1. Select System Config – Remotes – Edit.
The following is displayed:


2. EITHER:
a) Press the button on the remote control you want to re-program.
Hold down the button until you see the transmit LED flash.