User Menu Options
Page 59
To delete a specific remote control:
1. Select System Config – Remotes – Delete.
The following is displayed:
2. Press the button on the remote control you want to delete.
Alternatively, if you do not have the remote control, press , then use
or to choose the remote control, followed by .
A message similar to the following is displayed:
3. Press to delete the remote control.
Enabling or disabling unsetting
You can use System Config – Remotes – Unset to enable or disable the
ability for all remote controls to unset the system. By default, remote
controls are able to unset the system, but you may want to change this for
security reasons.
After selecting Unset, use or to select Enabled or Disabled, followed
by .
Disabling Unset does not affect the ability for remote controls to set the
system.
Enabling or disabling HUA functions
You can use System Config – Remotes – HUA Function to enable or
disable the ability for a two-way remote control to generate Hold-Up Alarms
(HUAs).
Note: The installer must first enable this feature by configuring "Basic"
confirmation mode. Doing so means that the system does not comply with
BS8243 or DD243.
After selecting HUA Function, use or to select Enabled or Disabled,
followed by .
See page 16 for details of how to generate an HUA using a two-way
remote control.
To Next Page
Loading...
