User Menu Options
Page 57
OR (if you do not have the remote control):
a) Press at the "Press Remote Button" prompt.
b) Use or followed by to select the remote control you
want to re-program.
c) The display lists the first button on the remote control:
d) Use or followed by to select the button you wish to re-
program.
The top line of the display shows the identity of the remote control, the
button you pressed or selected, and the name of the owner. For
example:
3. Use or followed by to choose the function for the button:
Note: If you have a partitioned system, the unset button can only be
used to unset some or all partitions allocated to the user. See Unset,
Unset All and Unset, Partitions below.
No Action For the button to have no action.
Part Set (two-way remote control only): To set part set B/C/D. For a
partitioned system, it applies only to the partition assigned
to the remote control. Use or followed by to select
the part set. The * key cannot be used to unset or full set.
Set/Unset (one-way remote control only): To set or unset the system.
Choose one of the following:
Unset, Unset All (partitioned system) – Unsets all
partitions that the user belongs to.
Unset, Partitions (partitioned system) – Unsets
selected partitions that the user belongs to. After
selecting this option, use or to scroll through the
partitions and use or to choose whether the
partition should be unset by the button. Press when
you have finished.
To Next Page
Loading...
