User Menu Options
Page 62
Expanders (Not available for i-on Compact.) For each expander,
this gives the expander's address, its type and the
version of software (firmware) installed.
Keypads (Not available for i-on Compact.) For each keypad, this
gives the keypad's address and the version of software
(firmware) installed.
Comms This gives information about any plug-on
communications module fitted and the control unit's
Ethernet connection. If required, please ask your
installer for details about the information displayed (as
documented in the Configuration Guide).
To use the About option:
1. Select About.
The following is displayed:
2. Press or followed by to select the option you require.
3. If applicable, press or followed by to select the sub-option.
4. If applicable, press or to display further information.
5. Press repeatedly to exit.
Pairing with the SecureConnect App
You can use the Pair App option to generate a pairing code for the
SecureConnect app. The app allows you to monitor and control your alarm
system over the internet from your mobile phone or tablet.
Note: Pair App is not available if Cloud Access is disabled in the Installer
menu or if App Access is disabled in your user settings (see page 39). The
option is also not available for users of type Set/Unset (see page 4).
The pairing code uniquely pairs your app with your panel and user code.
This ensures that any actions you carry out using the app will affect only
your panel, and are logged against your user code. You are prompted to
enter the code when you first open the app. The pairing code lasts for 15
minutes.
Please refer to the SecureConnect documentation for details of how to use
the app.
To Next Page
Loading...
