Product information
Introduction
This manual contains assembly and installation instructions
for Eaton's Cooper Power™ series KA146W5 single pole-
mounting hanger and the KA146W2 tank-lifting windlass.
Read this manual first
Read and understand the contents of this manual and
follow all locally approved procedures and safety practices
before installing or operating this equipment.
Additional information
These instructions cannot cover all details or vari ations in
the equipment, procedures, or process described, nor to
provide directions for meeting every possible contin gency
during installation, operation, or maintenance. For additional
information, contact your Eaton representative.
Acceptance and initial inspection
This product is completely assembled, tested, and
inspected at the factory. It is carefully calibrated, adjusted
and in good condition when accepted by the carrier for
shipment.
Upon receipt, inspect the carton for signs of damage.
Unpack the contents and inspect them thoroughly for
damage incurred during shipment. If damage is discovered,
file a claim with the carrier immediately.
Handling and storage
Be careful during handling and storage of this equipment to
minimize the possibility of damage.
Quality standards
ISO 9001 Certified Quality Management System
Description of operation
The KA146W5 suspension-type hanger enables the
mounting of Eaton's Cooper Power series three-phase
reclosers, GW and GWC sectionalizers, and VRV oil
switches on single poles. No crossarms are required.
The KA146W2 tank-lifting windlass is easily attached as
a unit to the back of the mounting hanger with only two
bolts. The windlass simplifies lowering the recloser tank
for inspection and maintenance, but can not be used for
lowering the entire recloser.
1KA146W5 AND KA146W2 ASSEMBLY AND INSTALLATION INSTRUCTIONS MN280039EN
To Next Page
Loading...
