What to do if Eaton SPEAR Industrial Electrical unit will not close?
If your Eaton Industrial Electrical unit won't close, ensure the yellow manual operating handle is fully up in the CLOSED position. Also, verify that all cables are properly connected. Finally, check the condition of the battery located in the control cabinet.
What to do if Eaton Industrial Electrical unit will not open?
If your Eaton Industrial Electrical unit won't open, first check that all cables are properly connected. Also, check the condition of the battery located in the control cabinet.
General| Brand | Eaton |
|---|---|
| Model | SPEAR |
| Category | Industrial Electrical |
| Language | English |
Emphasizes understanding manual and safety practices before operation.
Guidance on verifying recloser ratings against system characteristics.
Step-by-step instructions for safely removing the recloser from service.
Instructions for manually operating the recloser while energized.
Steps for programming the control before connecting to an energized recloser.
Grounding method for local supply transformers in 4-wire systems.
Grounding method for remote supply transformers in 4-wire systems.
Routine inspection and maintenance requirements for the recloser.
Procedure for safely discharging the trip and close capacitor.
Procedures for performing high-potential withstand tests on the recloser.
Steps to troubleshoot when the recloser fails to close.
Steps to troubleshoot when the recloser fails to open.
Tests for initial operation of the control while connected.
Steps to view battery information and perform a test on an installed battery.
Detailed steps for replacing the control's 24 VDC battery.
To Next Page