Eaton SVX900 - STEP 4 Operating & Programming Menu Navigation; Operate Menu Navigation; Programming Menu Access

MN04003009E
7
December 2003
STEP 4
Operating & Programming Menu Navigation
Output Freq
“29.6” Hz
O1
Freq Reference
“29.6” Hz
O2
Parameters
P1
P22
M1
Fault History
H1
H8
M4
Motor Speed
“885” rpm
O3
Motor Current
“0.09” A
O4
Keypad Control
M2
Motor Torque
“2.6” %
O5
Motor Power
“0.5” %
O6
Active Faults
F0
M3
Motor Voltage
“255.7” V
O7
DC – Bus Volt
“580” V
O8
Unit Temp.
“32°” C
O9
Motor Temp.
“0.1” %
O10 M5
Programming
“Press Enter”
M6
M7
Operate Mode
“Press Enter”
M8
Operate Menu Programming
System Menu
S1
S8
Expander Boards
G1
G5
Monitor
V1
M17
If the program were password
protected, the password would be
needed for access into the program.
You may log out of any of the above
parameters directly into “Programming”
by pressing the key for 2 seconds.
MN04003009E.fm Page 7 Thursday, February 17, 2005 11:59 AM