Eaton TSDW1COA-1 - Manual and Permanent Switching; Manual Control; Permanent Switching; Cancelling Manual;Permanent Switching

5
OPTIONS
MENU
u
u
u
u
OPERATING
HOUR
EXT INPUT
LANGAGE
PIN
FACTORY
SETTINGS
INFO
NO PIN
WITH PIN CURRENT PIN
NEW PIN
00:00
Setting manual or permanent switching
Manual and permanent switching can be set using the menu
in MANUAL or (in the automatic screen) by key combination
(see g).
•
Manual control
Reversing the channel status to the next automatic or
programmed switching.
•
Permanent switching
As long as a permanent switching (on or off) is activated,
the programmed switching times are ineffective.
ok
Activate manual switching
 Briey press both keys simultaneously
Activate permanent switching
 Simultaneously press both keys for 2 seconds
Cancelling manual/permanent switching
 Press both keys simultaneously
Operating hour counter
The operating hours of the channel (relay) are displayed and
deleted in the OPTIONS menu. If the number of operating
hours exceeds the value set in the Service menu, SERVICE will
appear in the display.
Example: Replace a lamp after 5,000 h.
 Delete operating hours or set a higher value in Service (e.g.
to 10,000 h)
Resetting the time switch
 Press the 4 buttons simultaneously.
▻ You can choose between RETAIN PROGRAM and DELETE
PROGRAM.
6. Technical Data
Operating voltage: 230 V AC +10 % / –15 %
Frequency: 50–60 Hz
Standby: 0,4 W
Max switching capacity.: 16 A (at 250 V AC, cos ϕ = 1)
Switching capacity: 10 A (at 250 V AC, cos ϕ = 0,6)
Min. switching capacity: 10 mA/230 V AC
100 mA/24 V AC/DC
Switch output: switching of any phase is
permitted
TSDW1COA-1: suitable for switching SELV (Safe
Extra-Low Voltage)
Protection rating: IP 20 in accordance with
EN 60529
Protection class: II in accordance with EN
60730-1 subject to designated
installation
Operating temperature: –30 °C … +60 °C
Power reserve: 10 years at +20 °C
Switching accuracy: accurate to the second
Time accuracy (typical) ± 0,25 s/day (25 °C)
Rated impulse voltage 4 kV
Pollution degree 2
Software class: A
Contact two way switch, contact µ
Max. switching cycles with 16 A resistive
load
50 000
Incandescent lamp load 2600 W
Halogen lamp load 2600 W
Fluorescent lamps (LLB low-loss bal-
lasts):
uncorrected
series-corrected
parallel-corrected
2600 VA
2600 VA
1300 VA (130 µF)
Compact uorescent lamps (EB) 1100 W
LED-lamps (< 2 W) 50 W
LED-lamps (> 2 W) 600 W
L The time switch display is only fully functional at tempera-
tures from +5 °C - +55 °C.
7. Contact
Eaton Industries (Austria) GmbH
Eugenia 1
A-3943 Schrems
Austria
Technical Support Center
TechSupportEMEA@eaton.com