EAW ADAPTive systems - Attaching Flybar to Distro Racks; Attaching Multiple Distro Racks

23
2. Slide Rigging Latch upwards and re-pin Rigging Latch to hold into place within
Rigging Channel
3. Lift to remove Distro Rack from Caster Pallet.
Note: Store Caster Pallets in a standing position in a safe location
Attaching Flybar to Distro Racks
1. Remove quick release pins from the fixed side Rigging
Latches of the Flybar.
2. Align Flybar Rigging Latches to match with the side
Rigging Channels on Distro Rack.
3. Re-pin the quick release pins to lock the Flybar to the
Distro Rack.
Attaching Multiple Distro Racks
1. Once detached from Caster Pallet, lift Distro Rack by either
physical or mechanical means on top of the next Distro
Rack.
2. The stacking pads/feet will aid in proper positioning of one
Distro Rack on top of the other.
3. Remove the two bottom quick release pins which will
release the bottom Rigging Latches directly into the
Rigging Channels of the Distro Rack below.
4. Re-pin the quick release pins into the bottom Distro Rack.
5. Repeat this step for additional Distro Racks to be flown.