KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01
KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01 Page 18 of 29
6. Bring in the flown enclosures to just touch the front top of the palleted KF761 enclosure.
7. Remove the two short connecting pins temporarily inserted into the front hinges. Engage the two front
hinges in their fully extended position into the Hinge Tubes of the flown enclosure. Secure each hinge in
place by using the top hole in the Hinge Tube of the upper enclosure using a short connecting pin.
8. Fly out the array until the front of the KF760 is a few inches off the pallet.
To Next Page
Loading...
