KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01
KF760 Series Rigging Procedures PRELIMINARY DRAFT -- 21 Aug 01 Page 27 of 29
7. Move the pallet loaded with the four KF760s out of the way.
8. Repeat the above steps for additional KF761s.
2.4.5 Last Group Of KF760S
239 to 249
1. Position an empty KF760 pallet under the array.
2. Drop the array onto the pallet until any rear splays close up and weight is just off the chain motors.
3. Ensure that the alignment pads on the bottom of the KF760 mate with their slots on the top of the
caster pallet rails. Ensure the Hinge Tubes on the bottommost enclosure mate with the hinge Tubes on
the pallet.
To Next Page
Loading...
