BD-150 OWNERS MANUAL Page 2 of 12
Drawing No. :- TPC161
Issue :- 2
Date :- 23/06/03
INTRODUCTION
Designed for a wide range of applications, the BD-150 dehumidifier is a super high capacity
industrial unit which provides fast and efficient drying.
The BD-150 has a number of special features:
• Super high efficiency rotary compressor
• Temperature-sensitive microprocessor controlled defrost system
• Exterior epoxy powder-coated finish
• Rugged trolley for portability
• Extra long power cord
The fan draws the moist air through the inlet grille on the back of the unit, then through the cold
evaporator coil, which cools the air below its dew point. Moisture forms on the evaporator coil
and is collected in the condensate tray, which is equipped with a permanent drain. The cooled
air then passes through the hot condenser coil where it is reheated using the same energy
removed during the cooling phase, plus the additional heat generated by the compressor. The air
is, therefore, discharged from the dehumidifier at a slightly higher temperature with a lower
absolute humidity than that which entered. Continuous circulation of air through the
dehumidifier gradually reduces the relative humidity within the area.
The BD-150 dehumidifier is a rugged, reliable drying unit designed to operate effectively over a
broad range of temperature and humidity conditions.
The unit incorporates a welded and galvanized steel chassis and is finished in an epoxy coating
for resilience to damage caused by rough handling.
To Next Page
Loading...
