39
www.eberg.eu
RIOPL
5.2 REMOTE CONTROL
5.3 SETTINGS
5.3.1 Start-up and shut down
• Press POWER to turn the unit on.
• The unit runs in in FAN as default.
• Press MODE button to select the desired operation mode.
• Press POWER again to turn o the power.
5.3.2 Operation mode
The unit has four operation modes: Cool, dry, fan, sleep.
A. Cooling your room
• Select the cool mode to lower the temperature in your room.
• Press MODE button repeatedly until the LED of COOL operation lights up.
• Press Up/Down button to adjust the temperature which is displayed on the screen. The
temperature can be set between 16°C and 32°C.
• Press SPEED button repeatedly until the desired fan speed indicator lights up.
• To control the direction of the air ow horizontally, please adjust the inner louver by hand.
Note The air conditioner stops if the room temperature is lower than selected temperature.
B. Ventilating your room
• Press MODE button repeatedly until the LED of FAN operation lights up.
• In ventilation mode the room air is circulated, but not cooled.
• Press SPEED button repeatedly to select the fan speed as desired.
C. Drying your room
• Press MODE button on the control panel or remote control, the LED of DRY operation lights
up. The fan speed is unable to select.
• User should connect the hose to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot be selected.
D. Sleep mode this function can only be used with a remote control
To Next Page
Loading...
