EBS REIDMAR
250 W BASS HEAD
D
ESIGNED AND DEVELOPED BY EBS SWEDEN AB
G
RINDSTUVÄGEN 44-46, SE-16733 BROMMA,SWEDEN
+46 8 735 00 10, FAX : +46 8 735 00 05
E-
MAIL:
*
(
ebs.info@bass.se
www.ebssweden.com
WEB:
Users Manual
250 W BASS HEAD
Contents: Page:
Introduction 2
Block Diagram 3
Front Panel Controls 4
Page:
Rear Panel Connections 6
Specifications 8
REIDMAR
INPUT:
GAIN:
CHARACTER:
COMP/LIMIT:
FILTER SECTION:
BALANCED OUTPUT:
EFFECT LOOP:
LINE OUT:
PHONES OUT:
POWER AMP:
AUXILIARY INFO:
Input Impedance 2 Mohms // 100 pF
Gain Range min/max -oo/ +30 dB
Gain Peak LED +10 dBv
Frequency Response +0 / -3 dB 20 - 20.000 Hz
Filter: Type Shelving High/Low Pass
Gain: Lo +7 dB @ 40 Hz
Mid -2 dB @ 800 Hz
Hi +3 dB @ 10 kHz
Compressor Gain 0 dB
Attenuation max 24 dB
Compression Ratio max 3:1
Attack (80%) typ <10 ms
Release (80%) typ 100 ms
Bass Filter: Type 12 dB/oct. Shelving
Gain Range +/- 18 dB @ 60 Hz
Middle Filter: Type Bandpass Filter
Frequency Range 100 - 6.000 Hz
Q - Boost 0.7 - 1.1
Q - Cut 0.8 - >10
Gain Range +/- 12-15 dB
Treble Filter: Type Shelving
Gain Range +/- 18 dB@6kHz
Bright: Type Shelving
Gain Range +15/-0 dB @ 10 kHz
Output Level Nominal -10dBv
Frequency Response +0/-3 dB 10 - 20k Hz
XLR Connections 1-GND, 2-Hot, 3-Cold
Options GND Lift, Pre/Post EQ
Loop Signal Level nominal -10 dBv
Gain Unity (1:1)
Output Impedance 100 ohms
Input Impedance >50 kohms // 100
Output Impedance 100 ohms
Signal Level nominal 0 dBv
Impedance recommended 32 - 200 ohms
Continuous Output Power @4 ohms 250 W RMS
@8 ohms 125 W RMS
Protection Short circuit,
High temperature
Power Requirements max 400 W
Mains Protection: T2A Fuse (230V)
T4A Fuse (100/120V)
Dimensions (WxDxH) max 36 cm x 25 cm x 7.5 cm
14” x 9.8” x 3.0”
Weight: 3.2 kg ( 7.1 lbs.)
Specifications are subject to change without notice!
SPECIFICATIONS
August 2011
To Next Page
Need help?
General
